Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Using high voltages in Joule heating

Please login with a confirmed email address before reporting spam

I am employing Joule heating in a 4.0a model to represent a liver cancer therapy. High voltages are generated between two cylinders that are supposed to represent electrodes. The model takes into account the changes in the properties of the materials with temperature.

When I use voltages <=4500V at one electrode, the simulation runs just fine. However, when I attempt 5000V, it freezes before completing. In employing the exact same model in 3.4, I never had this problem. However then I did not attempt to account for the change in the physical properties with temperature. What should I do?

The 4.0a model is attached.


0 Replies Last Post 29 nov 2010, 18:04 GMT-5
COMSOL Moderator

Hello Oyinlolu Adeyanju

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.