IXCmp 7.1e-4[kg*m^2] "Component mass moment of inertia around X axis"
IYZCmp 9.3e-4[kg*m^2] "Component mass moment of inertia around Y and Z axes"
mCmp 2.4[kg] "Component mass"
maxStressLimit 80[MPa] "Maximum allowed equivalent stress under 4g acceleration"
minFreq 60[Hz] "Lowest allowed natural frequency"
THK 4[mm] "Plate thickness"
LX 65[mm] "Bracket length"
LZ 70[mm] "Bracket height"
dCmp 40[mm] "Diameter of component"
bDia 8[mm] "Diameter of mounting bolts"
LY dCmp+4*bDia "Bracket width"
ZC 21[mm] "Z coordinate of the central hole"
ZO 37[mm] "Z coordinate of the outer hole"
YO LY/2-ROorig-YOOorig "Y coordinate of the outer hole"
RCorig 4[mm] "Original radius of central hole"
ZCOorig 5[mm] "Original distance from bend to bottom of central hole"
ROorig 5[mm] "Original radius of outer holes"
ZOOorig 20[mm] "Original distance from bend to bottom of outer hole"
YOOorig 8[mm] "Original distance from edge to outer hole"
RC 4[mm] "Radius of central hole"
ZCO 5[mm] "Distance from bend to bottom of central hole"
RO 5[mm] "Radius of outer holes"
ZOO 20[mm] "Distance from bend to bottom of outer hole"
YOO 8[mm] "Distance from edge to outer hole"
RCoff RCorig*(scaleRC-1) "Offset distance central hole"
ZCOdisp ZCO+RCoff-ZCOorig "Z displacement central hole"
ROoff RO-ROorig "Offset distance outer holes"
ZOOdisp ZOO+ROoff-ZOOorig "Z displacement of outer holes"
YOOdisp YOO+ROoff-YOOorig "Y displacement of outer hole"
scaleRC RC/RCorig "Scaling factor for central hole"
d_C_Cmp_Orig LZ-dCmp/2-ZC-RCorig "Original distance between edges of central hole and component"
d_O_O_Orig LY-2*YOOorig-2*ROorig "Original Distance between outer holes"
d_C_Cmp d_C_Cmp_Orig-RCoff-ZCOdisp "Distance between edges of central hole and component"
d_O_O d_O_O_Orig-2*(ROoff+YOOdisp) "Distance between outer holes"
d_O_Cmp sqrt((YO-YOOdisp)^2+(LZ-ZO-ZOOdisp)^2)-RO-ZOOorig-ROoff "Distance between edges of outer hole and component"
d_O_C sqrt((YO-YOOdisp)^2+(ZO-ZC-ZCOdisp+ZOOdisp)^2)-RO-RC-RCoff-ROoff "Distance between edges of outer and central holes"