Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

using loop in boundry conditions

Posted 27 lug 2010, 09:03 GMT-4 0 Replies

chattarbir singh
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Dear All

I have case where i want to simulate the rectangular duct which has repetitive internal design. As i have to make that in 3d, it is consuming lot space as i am getting more than 50000 mesh elements.

I can reduce the meshing if i am able to simuate the small length of duct with internal structure and then using loop to replace my inlet BC by the exit BC. Then i need to do that by many 100 times.

Please let me know if there is a way to do that in COMSOL 3.5a.

Kind Regards
Chattarbir Singh
0 Replies Last Post 27 lug 2010, 09:03 GMT-4
COMSOL Moderator

Hello chattarbir singh

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content