Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Reg weak form boundary condition

Posted 22 giu 2010, 20:03 GMT-4 1 Reply

Subhra Paul
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi All,

I have short question reg weak form on a boundary condition.

In my problem region I have conducting region and non-conducting region. My question is what would comsol assume if I do not put anything in the weak form boundary condition for the interface of the air and conducting region. Would it assume dirichlet condition (Az=0) or something else?

thanks in advance.
Subhra
1 Reply Last Post 23 giu 2010, 12:45 GMT-4
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 23 giu 2010, 12:45 GMT-4
Hi

the easist is normally to see what the COMSOL equations are, in 3.5 "Physics - Equation Settings - ... or turn on the equations in one of the subtabs of the preferences

Have fun Comsoling
Ivar
Hi the easist is normally to see what the COMSOL equations are, in 3.5 "Physics - Equation Settings - ... or turn on the equations in one of the subtabs of the preferences Have fun Comsoling Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content