Menu

Discussion Forum

New Discussion
Filtra

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

cap faces geometry

Posted 23 nov 2012, 08:10 GMT-5 Interfacing, Geometry, Mesh Version 4.2a, Version 4.3, Version 4.3a 1 Reply

Florian Breider
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello,

I imported my geometry from Solidworks using the "LiveLinks for SolidWorks" and I tried cap faces but every time I encountered the following error: "Edges must form simple loops".
Does anyone knows how to solve this problem?

Thank you in advance for your help.
Regards, Florian Breider
1 Reply Last Post 23 nov 2012, 09:39 GMT-5
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 23 nov 2012, 09:39 GMT-5
Hi

as it says, you need "simple loops, your geoemtry must do some funny loops, or changing plane orientation

--
Good luck
Ivar
Hi as it says, you need "simple loops, your geoemtry must do some funny loops, or changing plane orientation -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content