Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

results from Model2

Please login with a confirmed email address before reporting spam


Hi

I have 2 models in my file, model 1 with geometry 1 and model 2 with geometry 2.
At present there is no model coupling. After running the file I can see the results from model1
but when I try to see results from model 2 I get the following message:

Failed to evaluate variable
-Variable: mod2.p2
-Geometry:1
-Domain:1

Why does it look in geometry 1 instead of geometry 2?

please help

David

1 Reply Last Post 14 dic 2011, 09:46 GMT-5
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 14 dic 2011, 09:46 GMT-5
Hi

check your study nodes, there you decide which geometry, mesh and studies that are used together

--
Good luck
Ivar
Hi check your study nodes, there you decide which geometry, mesh and studies that are used together -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.