Menu

Discussion Forum

New Discussion
Filtra

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Half Sphere

Posted 24 nov 2010, 07:50 GMT-5 2 Replies

Malvina Billeres
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I'm trying under COMSOL 4.0 to build a half sphere ... how can I manage ?
thanks
2 Replies Last Post 24 nov 2010, 08:54 GMT-5
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 24 nov 2010, 08:42 GMT-5
Hi

try out: make a full sphere, add a large block covering the half (boundary pasing through the sphere centre) and you can even in 4.1 use a workplane passing by the sphere centre to "box" the cut circle, and extrude at least to R the sphere radius.

Then use the difference bolean operation.

Its the same method as for 2D

--
Good luck
Ivar
Hi try out: make a full sphere, add a large block covering the half (boundary pasing through the sphere centre) and you can even in 4.1 use a workplane passing by the sphere centre to "box" the cut circle, and extrude at least to R the sphere radius. Then use the difference bolean operation. Its the same method as for 2D -- Good luck Ivar
Malvina Billeres
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 24 nov 2010, 08:54 GMT-5
thanks !
thanks !

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content